Palladium Pallashock Backzip 2: Easy On and Off Boot Guide

By The Official US Palladium Boots Online Shop – Palladium US | Published: 2026-10-23

Category: How-to Guides

Learn how to effortlessly put on and take off your Palladium Pallashock Backzip 2 boots with this step-by-step guide, including tips for styling and care.

Quick answer

The Palladium Pallashock Backzip 2 is designed for easy on and off thanks to its convenient side zip, but getting the fit right and avoiding zipper snags takes a few simple steps.

Why the Backzip Design Works

The Pallashock Backzip 2 features a full-length zip on the outside of the boot, which lets you slip your foot in and out without constantly retying the laces. This is especially handy for quick changes or when you wear the boots with different sock thicknesses. The zip is sturdy and runs the height of the shaft, so it won't catch on the inner lining if you follow the proper sequence.

A Note on Fit and Sizing

These boots are designed for women and have a classic moleskin canvas upper with suede toe accents. The canvas will give slightly with wear, but the zip mechanism means you can adjust the laces once and then rely on the zip for daily entry. If you're between sizes, consider going up half a size to accommodate thicker socks without over-stressing the zipper.

How to Put On and Take Off Your Pallashock Backzip 2

1. Loosen the laces fully before zipping: Unlace the top two eyelets to create enough space for your foot to slide in. Then unzip the side zipper completely. Common mistake: trying to zip up over a tight lace section, which strains the zipper. Always loosen laces first to protect the zipper mechanism.
2. Insert your foot and align the heel: Slide your foot in while holding the boot open with one hand. Make sure your heel sits flat against the back of the boot before you start zipping. Common mistake: forcing the zipper when the heel is not fully seated, which can cause the zipper to jam. Check heel position before zipping to avoid jams.
3. Zip up slowly from bottom to top: Hold the zipper pull and zip upward in one smooth motion. If you feel resistance, stop and check for fabric caught in the teeth. Common mistake: yanking the zipper past a snag, which can bend the teeth. Zip slowly and stop at the first sign of resistance.
4. Tighten laces to your preferred fit: Once the zip is closed, pull the laces snug from the top down. Tie a secure bow or knot. Common mistake: over-tightening the top eyelets, which puts unnecessary pressure on the zip. Lace snugly but avoid pulling the top eyelets too tight.
5. To remove, reverse the process: Untie the laces, unzip the side zipper completely, and gently pull your foot out while holding the heel. Common mistake: trying to remove the boot without unzipping fully, which stretches the collar. Always unzip fully before pulling off the boot.

Product Facts

94469-116-M | PALLASHOCK BACKZIP 2 | STAR WHITE: The Pallashock Backzip 2 is a feminine high-top sneaker with a classic moleskin canvas base and suede accents on the toe. The moleskin canvas is durable yet flexible, so the boot won't pinch your foot when you use the side zip for quick entry.
94469-116-M | PALLASHOCK BACKZIP 2 | STAR WHITE